Easy DIY Button Bracelets
Unleash your creativity with our easy and super simple button bracelets diy tutorial! Crafted with big pretty buttons and macrame cords, it’s a fun and stylish accessory to make in no time! Easy, simple, and loads of fun
Equipment
- Flat nose pliers {using 2 is best}
- scissors
Ingredients
- Cute and large buttons
- Cord {I used jewelry macramé cord}
- 2 Jump rings
- Clasp
- 2 Fold Over Cord Ends
Instructions
- Cut the cord into two equal length strings – around 8- Inches, depending on your wrist size and the button size. Cut more if you want to make more than one bracelet in different colors like I did.
- Fold one piece of cord in half and insert the folded end through one of the holes from the back to the front side of the button.
- Insert the opposite ends of the thread through the cord loop.
- Pull tight and try to make sure that the cord ends stay relatively even.
- Repeat the process with the other hole of the button.
- To close the bracelet, measure your wrist first by placing the button on your wrist and meeting both ends of the cords.
- Make a mark to know where they meet. Leave a few millimeters and cut.
- You can make a knot at the very end with both strings. so the cord crip grips better.
- Place the two ends of one side of the bracelet into the fold over cord crimp or cord end.
- Carefully fold one side of the cord end down onto the macramé cord with the flat nose pliers. Then fold the other side down.
- Finally, insert jump rings into the cord end and attach the clasp.
- You are done!!! Yayyyyyy.
- Repeat the process with as many bracelets as you want!